Go to the downloads page within the portal.
Under the Active Directory Connector subheading, you will find ‘Active Directory Connector’.
You can then select to download the MSI, This will then bring up the Active Directory Connector installation window, you can then select the organisation you want the agent to be installed under, and click ‘Download
After Downloading your MSI, please install it onto a server which uses Active Directory
Confirm the service is started on the system
Ports
*The default port for the web dashboard is 5860 however if this port is in use by another application, it may change. To find out the new port the connector is assigned to, please do the following steps*
You can use the resource monitor included in Windows, to find the port that a service is using. once it loads, please navigate to the Network tab.
On this tab, you’ll have 4 blocks of different information, we want to be using the last one titled Listening ports.
Here you’ll be able to find which port the AD sync connector is using
Configuration
Open up a supported web browser and navigate to the url Http://localhost:5860 this should automatically route you to http://localhost:5860/#/schedule-scan, however if there is any issue please use the second link.
On this page you can setup the hour and minutes you would like to scan on a daily basis
Once you have setup your schedule, this will trigger at the inputted time. However if you’d like to trigger your scan immediately, please navigate to http://localhost:5860/hangfire
Now click on the Recurring Jobs tab in order to view your scheduled job.
Tick the job this is currently in there, and then tap the Trigger Now button. You will see the Jobs tab change to 1, this indicates the scan is now running.
Finally head back into the Roboshadow portal and we can access the Management page to see the AD devices being synchronised.
